Can you help me

Konu: Can you help me

Hi @emeli

Zodiac1900-Termal1900ci,

There isn't the difference.

Konu: Can you help me


Hi Engineer
I read other your post and I noted your competence, then I hope you can help me with my problem.

I cannot upgrade my Zodiac decoder with new software, and an error message of download fail is shown by arioner 0.24. I think that this is due to an error in the header.

The software 5372 for S190 Termal that I loaded, was converted for Zodiac1900CI with aucedit. The boot is 17.1. The decoder is now recognized as termal 1900CI.

When I attempt to load new firmwares I have to convert it for Zodiac or to Termal with Auc_Hedit In this last case, since termal decoders are not present in the program Auc_Hedit, how I can convert the firmaware Is the conversion with similar decoders Termal 1900, Arion Af5018 etc really important

An other questions, excuse me for abuse of your time:
Can I return back with the original Zodiac software and then use an other boot and an other version of the firmware

Tank for your cortesy

Konu: Can you help me

Okey.
Do with AutoArioner to the predicate.

Konu: Can you help me

Hi emili!
If you want to return back with the original Zodiac software you have to upgrade your receiver with the original Zodiac software. There isn't any difference between zodiac software and others. From now on you should use autoarioner loader programme so as not to face any difficulty. You can learn how to use this programme from this link
http://www.ozmena.com/showthread.php?t=31382 ...
GooD LucK

Konu: Can you help me

Tank you to all for the suggestions

I have already maded really a great numbers of attemmpts with various programs. I can load some firmwares for Termal (S190) with Arioner0.24 but not the firmware for AF 5018 or Ferguson or other decoders that are the same of my Zodiac 1900Ci.

Autoarioner was one of my first attempts. It don't recognize the firmware loaded in my decoder and stay always in scansion state on the port where I connect the decoder without recognize the firmawere version. I think it is a problem of header but I am not sure of this.

Yesterday However I loaded the new firmware published by Engineer (I am grateful with him for his excellent work) with Arion 0.24 then, for the moment the problem is solved. But I would like understand why it is not possible to use Autoarioner and/or to load other firmware. I think that I maded an error the first time that I loaded the firmware and then I would to back to the original version and reloaded it.

Tanks again to all of us.